 |
Page Navigator |
|
1. Air Intake 2. Alternator 3. Brackets 4. Compressor 5. Oil Filter 6. Plumbing 1 7. Plumbing 2
More Projects
- Knowledge - Maintenance - About
|
Featured Links |
| Kilby Enterprises |
 |
 Projects On Board Air |
| Page 5 - Oil Filter | April, 2005 | |
 |
 |
|
| Plumbing the coalescing filter. | The filter mounted on the firewall. | |
|
The OBA compressor will put small amounts of oil in the air. You should have a coalescing filter as the first component in the plumbing. But, not too close to the compressor. Use at least 4 feet of air hose between the compressor and the filter.
Kilby provides a smaller diameter hose to connect the drain side (bottom) of the filter to the compressor. He also provides a manual valve to keep the drain closed until your filter is full. I mounted the filter on the firewall. Kilby provides a nice bracket. I used about 5 feet of air hose and cable tied it to the engine compartment strut, which is now back in place. |
||
| << Page 4 - Compressor << | >> Page 6 - Plumbing 1 >> | |
| All content Copyright © NakedJeep. Jeep is a registered trademark of DaimlerChrysler. |
||
 |
||