 |
 Projects Hand Throttle |
| Page 2 - Spacer Fab | March, 2003 | |
 |
 |
|
| Cut a section of PVC to size. | Shifter and the new spacer. | |
|
I plan on putting the throttle on my gear shift lever, but the bicycle shifter was made for bicycle handle bars, and they have a bit larger diameter. I need a spacer. Looking around the garage I found some schedule 80 PVC left over from a sprinkler project. Perfect!
I cut a small section of pipe about an inch long. Then I split it into 2 pieces so I could sandwich it around the gear shift lever and clamp the biclycle shifter over it. A little black paint to finish it off and we're done. |
||
| << Page 1 - Bicycle Parts << | >> Page 3 - Mounting >> | |
| All content Copyright © NakedJeep. Jeep is a registered trademark of DaimlerChrysler. |
||
 |
||