 |
Page Navigator |
|
1. - Intro 2. - End Caps 3. - X-Member 4. - Drilling 7. - Gussets 6. - Mounting 7. - Swinging 8. - Lite & Cans 9. - Hi-Lift 10. - Spare
More Projects
- Destinations
|
Featured Links |
|
Bulletproof Hi-Lift |
 |
 Projects Bulletproof Rear Bumper |
| Page 9 - Hi-Lift | July, 2002 | |
|
The plastic from the third brake light has to be trimmed back to allow the Hi-Lift jack to mount. I used a short piece of pipe insulation to keep the handle from rattling. They provide wing nuts for mounting and room for a padlock. Make sure you test the position of the jack with the swing out completely open so that it does not hit your Jeep. |
||
 |
 |
|
| Figure 20 - Hi-Lift jack in place. | Figure 21 - Cans and Hi-Lift in place. | |
| << Page 8 - Lite & Cans << | >> Page 10 - Spare >> | |
| All content Copyright © NakedJeep. Jeep is a registered trademark of DaimlerChrysler. |
||
 |
||