 |
Page Navigator |
|
1. - Intro 2. - End Caps 3. - X-Member 4. - Drilling 7. - Gussets 6. - Mounting 7. - Swinging 8. - Lite & Cans 9. - Hi-Lift 10. - Spare
More Projects
- Destinations
|
Featured Links |
| Bulletproof |
 |
 Projects Bulletproof Rear Bumper |
| Page 8 - Lite & Cans | July, 2002 | |
|
It has been a while and I am finally finishing this write up with the details on how the cans, hi-lift and thrid brake light all get mounted. |
||
 |
 |
|
| Figure 18 - Brake light relocation. | Figure 19 - Fuel can mounting. | |
|
Bulletproof sells the third brake light relocation mount. Its is a bit expensive and there is not much to it. You could probably figure out how to do this cheaper. Its a hollow section of square tubing with 2 u-bolts. You need to drill new mounting holes in the plastic.
The gas cans rest on the small ridge on the bottom of the swing out and a clamp comes down on the top of the handle. The latch is adjustable to accomodate variations in the cans and there is a place for a lock on the latch. |
||
| << Page 7 - Swinging << | >> Page 9 - Hi-Lift >> | |
| All content Copyright © NakedJeep. Jeep is a registered trademark of DaimlerChrysler. |
||
 |
||