 |
Page Navigator |
|
1. - Intro 2. - End Caps 3. - X-Member 4. - Drilling 7. - Gussets 6. - Mounting 7. - Swinging 8. - Lite & Cans 9. - Hi-Lift 10. - Spare
More Projects
- Destinations
|
Featured Links |
| Bulletproof |
 |
 Projects Bulletproof Rear Bumper |
| Page 7 - Swinging | July, 2002 | |
|
Uh oh! Our holes don't line up! Not surprising. The new holes are a little high and just a bit outside. I had to slot each of the new holes a bit before I could get all 8 bolts into the bumper. You can now tighten all 8 bolts into the bumper and the 4 nuts and bolts on the crossmember supports. Replace the 2 bolts (Figure 4) from the original bumper that mount upward from the bottom of the new bumper. |
||
 |
 |
|
| Figure 16 - Carrier mounting location. | Figure 17 - Rear bumper and carrier. | |
| Look good? I think so. Carefully slide the fuel tank back in place and replace all of the nuts. Add the D-Rings and you're done with the bumper. On to the swingout tire carrier. The swingout mounts on a single pivoting bolt. The bolt is a tight fit. Make sure you get it in the right direction because once you get it in place it is not coming out without a press. | ||
| << Page 6 - Mounting << | >> Page 8 - Lite & Cans >> | |
| All content Copyright © NakedJeep. Jeep is a registered trademark of DaimlerChrysler. |
||
 |
||